The maintenance and the maintenance of the bearing

The maintenance and the maintenance of the bearing
1. The use of bearing cooling system.Bearing under the condition of cooling water in the correct use of not only prolong the service life of bearing seat, and improve production efficiency.Bearing material generally is made through a variety of special bearing steel processing, again good bearing steel also have their use of blame, such as temperature.Bearing in the condition of use, if the mold temperature is too high, it would be easy to make mold core surface and early turtle crack, some bearing seat is not even more than 2000 times turtle crack and large area.Even bearing in production because of bearing high temperature mold core are changed color, the measured even reached more than four hundred degrees, the temperature meet again in the release agent is easy to appear crack, under the condition of chilling production of products is also easy to deformation, strain, sticky mold, and so on and so forth.In the case of using bearing cooling water can greatly reduce the use of release agent, so operators don't use the release agent to reduce the temperature of the bearing.The advantage is to effectively extend the service life of bearing seat, save die casting cycle, improve product quality, reduce the viscous modulus and strain and viscose aluminum case, reduce the use of release agent.Also can reduce the push rod caused by overheating bearing temperature and core loss.
2. Bearing seat at the start of production in the process of the bearing must be preheated, prevent the cold hot metal bearing suddenly and cause turtle crack appeared, more complex bearing can use burner, liquefied gas, die temperature machine, with good condition relatively simple bearing can use slow injection preheating.
3. Clear for bearing the parting surface, it is very trouble, also is very easy to overlook, operators use kerosene on parting surface bearing cleaning thoroughly again, not only can prevent the bearing seat will not be against, and after cleaning, can put the bearing was the remains of the release agent or other dirt jam exhaust slot through, is advantageous to the gas discharge in injection mold during the process of improving product quality.
4. If the bearing seat equipped with neutrons control, pay attention to the signal lines between absolute ban on die casting machine and the bearing has a joint phenomenon, the reason is very clear, in the daily production, it is hard to avoid signal lines touch water, easily broken or joint bandage, resulting in the nipple and machine tool, if error caused by signal, light alarm, automatic stop delay time or signal is disorder, the bearing cap.Cause unnecessary losses.Travel switch attention to waterproof.
Supplier

BMB Bearings ia a precision bearing enterprise specializing in the production of double row angular contact ball bearings, double row deep groove ball bearings, and single row angular contact ball bearings. The company is a end bearings manufacturer enterprise producing double row angular contact ball bearings in China. Its models cover 3200 series, 3300 series, 3000 series, 3800 series, 3900 series, etc. The product accuracy grades are: P0, P6, P5, P4, and the products are widely applicable.
The company also maintains an extensive inventory of superior roller bearings, ball bearings, Deep Groove Ball Bearings, Selfaligning ball bearing, Angular Contact Ball Bearings, Thrust Ball Bearings and much more.